29102-15 (Oxyfuel Cutting) Study Guide Questions And Correct Answers

Bad gouging at the bottom of the cut {Ans: Insufficient preheat during an oxyfuel cutting operation is likely to result in _________.}Each time it is used {Ans: An oxyfuel cutting torch should be checked for leaks _______.}Oxyfuel cutting {Ans: The most suitable process to use on ferrous metals such as straight carbon steel is _______.}15-to-20-degree angle {Ans: When cutting thin steel with oxyfuel cutting equipment, point the torch tip in the direction the torch is traveling at a _________.}Distortion {Ans: What becomes less of a problem as the thickness of the steel being cut increases?}A face shield over safety glasses {Ans: When performing oxyfuel cutting, it is acceptable to wear __________.}Injector torch {Ans: The type of cutting torch that used a vacuum created by oxygen flow to draw in fuel from a very-low-pressure fuel sources is a _______.}Ferrous metals {Ans: Oxyfuel cutting is best suited for use on __________.}Gouging {Ans: The process of cutting a groove into a surface is known as _________.}212 F (100 C) {Ans: In the top and bottom of an acetylene cylinder are safety plugs with a melting point of _______.}Fill it with water {Ans: